By Introduction
According to Mark Roemer Oakland, it’s essential to stabilize the foundation of your house as soon as you notice negative signs such as breaks in the foundations and dividers, holes between the wall and the deck, unlevelled regions, and more. There are many different methods that can be used for foundation stabilization, and you have to carefully consider each option to get the best results.
The Guide
Here is a quick guide to different types of foundation stabilization options:
1. Steel piers – Using steel piers is a solid and proven method for foundation stabilization and is also the most recommended option by structural engineers. It’s especially useful for foundations that have started to shift or sink into unstable ground.
In this method, epoxy-coated or galvanized steel is connected together, and a hydraulic ram is utilized to drive the steel piers deep into the stable, load-bearing soil to support your home and prevent it from settling in further.
2. Concrete piers – Using concrete piers is a time-consuming, messier, and more labor-intensive method compared to other options. To make concrete piers, first, holes are drilled under the existing foundation of the home and then concrete is poured inside them. The whole process along with the complete installation takes about 3 weeks to complete since the concrete requires time to harden.
3. Mudjacking– Mudjacking is not a suitable option for repairing the foundation of your home. It is only suitable for repairing and raising garages, sidewalks, and basement floors if suitable. Typically, mudjacking works well for raising small concrete layouts.
Typically, this method requires the drilling of holes into the existing concrete slab and then the pouring of a new concrete mixture to add another level of stabilization.
4. Concrete press piles – Concrete press piles are preset concrete columns that can be pushed into the ground under the existing foundation of your home. Since these don’t require any time to harden like poured concrete and can be used immediately, the installation process can be completed much faster. These are a more budget-friendly option compared to steel piers but are more likely to shift over time since these are not attached to the home’s foundation.
5. Helical steel piers – Helical steel piers contain spiral blades on the lower ends which enable them to be twisted into the ground with a hydraulic torque motor. They don’t have to be driven as deep as driven piers but still contain the necessary load-bearing capacity since they come pre-tested.
However, experts believe that this method is more expensive and takes more time to install than steel piers and is still inferior to steel piers.
Conclusion
Your home is only as good as the foundation and delaying the repair work can put your whole family in danger. Mark Roemer Oakland suggests you hire a reputed foundation repair company to repair the foundation of your home. Ensure that you do your homework to understand all the safety risks and ensure that your home’s foundation stays strong for years to come.
Comments